My lathe came with an original equipment drive spur center and a 3-inch faceplate. These are right-hand threaded at 7/8-14 tpi. You'll need a 1-1/8 inch open end or spanner wrench to loosen or tighten the drive center. Apparently there was a 6-inch diameter faceplate for the lathe as well but the seller had somehow lost track of it over the years.
Also included with the lathe that I bought were a Morse Taper #1 dead center and a cup center for use in the tailstock. These latter items were also original equipment.
The above standard accessories are sufficient for turning spindles and small bowls.
No comments:
Post a Comment