An Inexpensive Entry Into Woodturning

From the questions I've answered for others in the past, I have learned that I am not alone in having acquired this lathe relatively inexpensively. I paid 85 USD for it some 7 or 8 years ago. For that price it came with a complete set of Delta chisels and a 3-inch faceplate, as well. All I had to do was drive 50 miles to pick it up. I think it was quite a bargain, considering that contemporary lathes of similar size and quality cost at least four times that much.

Why so cheap, especially since there was nothing mechanically wrong with it?

There are three limitations that seem to dictate the price:

• You will have a hard time finding or buying tooling for it because the headstock spindle threads measure 7/8-14 tpi. It seems that the lathe manufacturing industry has settled on 3/4-16, and 1.25-8 tpi as "standard" sizes for auxilliary tooling.
  
  
• The headstock spindle is solid. It does not have a Morse Taper socket.
  
  
• The tailstock spindle, while it accepts standard Morse Taper #1 tooling, does not have a thru-hole to permit deep drilling, such as one might do with a lamp auger.

In my opinion none of these limitations are or should be considered fatal impediments to buying or using this lathe because they all may be easily worked around. Subsequent blog postings will discuss these matters in more detail.